Reference projects
Projects built by our team members before the company was founded — across electronics, software and mechanics.



Mechanical · Electronics · Software
High-performance EV battery pack — 864 lithium-ion cells arranged 8p108s for 8 kWh at 450 V DC, delivering 80 kW peak and 30 kW continuous. CFD-driven forced-air cooling kept cells under 60 °C at 40 °C ambient, validated against measurements on the running pack. Mechanical design, thermal management, BMS hardware and firmware.

Mechanical · Semiconductors
Precision aligner for the IOM-CNR materials-science research institute (Basovizza, Trieste). Aligns a 2-inch GaAs wafer with a 4-inch silicon stencil mask under an inverted microscope across four axes, then transfers the aligned stack into a vacuum evaporator without losing alignment. Specification, CAD, magnetic-force and vacuum-flow calculations, BOM, drawings and delivered hardware in three months.

Electronics · Mechanical · Software
A retrofit that turns a standard commercial dishwasher into a pay-per-use machine. An ultra-low-power STM32L0 controller listens to the appliance’s own status bus to know when the machine is ready, and releases the wash cycle only once payment is confirmed; the dishwasher otherwise operates exactly as before. The controller lives in a custom enclosure designed to fit the machine.


Electronics · Mechanical · Software
Saturates a sintered-ferrite arc magnet radially, through its 20 mm wall. A 2200 µF / 450 V bank charged to ~325 V delivers ~115 J per shot — ~88 A peak — reaching 1200 kA/m in the magnet, even across a 4 mm air gap. Thyristor switch with an isolated pulse-transformer gate drive. One button runs the whole sequence — charge, delay, discharge — with indicator lights and adjustable timings.



Electronics · Software
Three-phase MOSFET inverter for an e-bike motor, 60 V / 20 A: power stage, gate drivers, current sensing and control firmware.


Mechanical · Electronics · Software
Two-wheeled self-balancing vehicle, designed, fabricated, wired and programmed end-to-end in six months. Aluminium chassis modelled in CAD, then waterjet-cut, CNC-bent and TIG-welded. Twin 24 V / 250 W motors; a 6-axis IMU read at 100 Hz holds the rider upright on a tunable PID loop.
Mechanical · Electronics · Software
Automatic drive for a hinged door: mechanical design of the drive and mounting, motor control, and operation by remote and phone.
Tell us about it — we’ll say honestly if and how we can help.